Bunny with ice cream

TinkerCAd reflection

1. Describe the object you built:

I built a bunny with an ice cream cone and no tail.

2)  List the steps it took to design your 3d object:

1. First I took an egg and put a bunny ear and folded bunny ear
2. Then I put a hand and an ice cream on the hand, looking as if the bunny was holding it.

3.then i thought about the eyes and I put a white ball on each side.

4. Then I put a black ball on each white ball to make it look like eyes. I also put a nose

3)  How did you decide to build this object?

I built this object because…

I built Bunny because i didn’t know what to make. I looked at the “characters” zone and I found an egg. I thought about easter and then I got it. I thought about making a bunny with… an ice cream cone!

4)  If you had more time or materials (plastic), how would you improve your object?

I would add or change….

I was very excited when I added the nose and ice cream that I forgot to put a tail on the bunny. If I wasn’t so excited of finishing and not re-checking it to see if it was good, I sure would’ve added the tail.

5) Add a picture of your 3D printed object below:

This is Bunny: ( he came out red):